Modify Selection
- Mine locations, excavations, and structures:
- Sumps
- or
- Slopes
- or
- Material piles
- or
- Mine surface
- or
- Laboratories
- or
- Stoppings
- or
- Caves
- or
- Faces
- or
- Offices
- or
- Boreholes
- or
- Stopes
- or
- Highwalls
- or
- Underground
- or
- Tunnels
- or
- Crosscuts
- or
- Pillars
- or
- Yield pillars
- or
- Barrier pillars
- or
- Chain pillars
- or
- Web pillars
- or
- Returns
- or
- Escapeways
- or
- Gobs
- or
- Airways
- or
- Bulkheads
- or
- Intersections
- or
- Longwall panels
- or
- Headgates
- or
- Recovery rooms
- or
- Tailgates
- or
- Entries
- or
- Bleeder entries
- or
- Intake entries
- or
- Panel entries
- or
- Belt entries
- or
- Drifts
- or
- Ore passes
- or
- Ore chutes
- or
- Wells
- or
- Drainage wells
- or
- Water wells
- or
- Storage structures
- or
- Hoppers
- or
- Silos
- or
- Trenches
- or
- Processing plants
- or
- Benches
- or
- Manholes
- or
- Shafts
- or
- Transformer stations
Home Links
Results 131 - 140 of 348
-
7/1/2008 - Conference papersIn this NIOSH study to optimize standing roof support design, ground response curves were developed for longwall tailgate conditions from numerical models of Pittsburgh Coal Seam geology.
-
7/1/2008 - Conference papersThis paper examines catastrophic failures of evaporite mines (including salt, potash and trona) that show that violent failure does, in fact, occur and attempts to identify common factors and characterize the mechanism of failure.
-
6/1/2008 - Peer reviewed journal articlesThis paper describes a modeling approach that can be used as a tool to evaluate potential roof failure and optimize the stability of room and pillar layouts.
-
6/1/2008 - Conference papersThis paper compares the transverse load capabilities of several block materials and wall dimensions commonly used in stopping constructions based upon simulated three-hinge, rigid-arch loading tests of half-wall constructions.
-
The guidelines in this report are to be used as a tool to identify areas or conditions that could impact the long-term stability of an underground fluid retention system and to give direction in addressing these situations.
-
6/1/2008 - Peer reviewed journal articlesThis paper describes the 3D velocity tomograms that were generated to image the stress redistribution around an underground coal longwall panel to produce a better understanding of the mechanisms that lead to ground failure, especially rockbursts.
-
6/1/2008 - Conference papersThe objective of the research was to cost-effectively increase the air cleaning volume and improve dust capture efficiency of an off-the-shelf dust collector with a larger motor and blower.
-
3/1/2008 - Conference papersSome surprising results were revealed in this study designed and implemented by NIOSH to evaluate the effectiveness of pre-driven longwall recovery rooms supported with pumpable concrete roof supports.
-
2/1/2008 - Conference papersThis paper describes NIOSH research demonstrating that the ventilation of large-opening mines improves significantly by including ventilation requirements in the mine planning process and implementing some practical techniques during mining.
-
11/1/2007 - Peer reviewed journal articlesThis paper discusses a method to determine the roof fall risk using a qualitative risk analysis technique.
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program